BINARY FILE LOADER FOR POLY-88xx COMPUTERS

Loads a ready to execute binary file into RAM at 3200h
through the printer serial port.

Press CTRL-Z to enter the front panel mode and type the
bytes of this program in at 8000h:

  L8000<CR> then type in each byte in hex with a space
  between each byte. The addresses shown below are for
  reference only - do not type in the address values.


   8000: CD AD 02 1F AA 40 4E 00
   8008: F3 3E 26 D3 01 21 00 32
   8010: DB 01 E6 02 CA 10 80 DB
   8018: 00 77 23 C3 10 80

Execute the program by jumping to it:

   SPJ8000<CR>G

Send the file in 8 bit binary mode from the PC. After the 
file has been sent, boot the computer and use the SAVE
command in Exec to save the file to disk. Or to run the
program, reset the computer and re-enter front panel mode
by typing CTRL-Z. Jump to the loaded program at 3200h:
   
   SPJ3200<CR>G