LG CD-ROM CRD-8322B 1.02 ATAPI characteristics: ATAPI device Model: CRD-8322B Firmware revision: 1.02 Supported ATA versions: ATA-1 ATA/ATAPI-4 Maximum ATA revision supported: Minor ATA version not specified Parallel ATA device: PIO timing mode: 4 DMA timing mode: 2 Advanced PIO: PIO0 PIO1 Multi-word DMA: MDMA0 MDMA1 MDMA2 (active) ATAPI CD-ROM/DVD/etc device Device shall set DRQ within 50 µs of receiving PACKET ATAPI device uses 12 byte command packet Device capabilities: IORDY is supported and can be disabled DMA is supported At minimum 120 ns. transfer cycle time per word in MDMA, 120 ns. recommended At minimum 120 ns. transfer cycle time per word in PIO, without flow control At minimum 120 ns. transfer cycle time per word in PIO, with IORDY flow control Command set and features: 28-bit LBA is supported SCSI characteristics: Vendor: LG (LG Electronics Inc.) Product: CD-ROM CRD-8322B Revision: 1.02 Device is connected and supported. CD-ROM/DVD/etc device Device claims to comply with ANSI X3.408:2005 (SPC-3) Device does not claim to comply with any SCSI ECMA standard Device does not claim to comply with any SCSI ISO/IEC standard Device is removable Device supports setting Normal ACA Device supports LUN hierarchical addressing Device does not support asymmetrical access Device supports only ST clocking Device supports MODE SENSE (10) Device supports MODE SENSE subpages SCSI mode sense pages: Mode Contents MODE page 01h SCSI Read error recovery page for MultiMedia Devices: Drive will repeat read operations 30 times All available recovery procedures will be used. Recovered errors will not be reported. Unrecovered ECC errors will return CHECK CONDITION. MODE page 0Dh SCSI CD-ROM parameters page: Drive will remain in track hold state 4 minutes after a seek or read Each minute has 60 seconds Each second has 75 frames MODE page 0Eh SCSI CD-ROM audio control parameters page: Drive will return from playback command immediately Output port 0 has channels 0 at maximum volume Output port 1 has channels 1 at maximum volume MODE page 2Ah SCSI CD-ROM capabilities page: Drive can play audio Drive can read sectors in Mode 2 Form 1 format Drive can read sectors in Mode 2 Form 2 format Drive supports multi-session discs and/or Photo-CD Drive can read digital audio Drive can continue from streaming loss Drive can read uncorrected and interleaved R-W subchannels Drive can read Media Catalogue Number Drive can read ISRC Drive uses a tray Drive can lock media Drive is not locked, media can be ejected and inserted Drive can eject media Each channel can be muted independently Each channel's volume can be controlled independently Drive supports 255 volume levels Drive has 128 Kbyte of buffer Drive's maximum reading speed is 5632 Kbyte/sec. Drive's current reading speed is 5632 Kbyte/sec. Drive can read CD-R SCSI CD-ROM capabilities: Drive can continue from streaming loss Drive can eject media Drive can lock media Drive can play audio Drive can read CD-R Drive can read digital audio Drive can read ISRC Drive can read Media Catalogue Number Drive can read sectors in Mode 2 Form 1 format Drive can read sectors in Mode 2 Form 2 format Drive can read uncorrected and interleaved R-W subchannels Drive has 128 Kbyte of buffer Drive is not locked, media can be ejected and inserted Drive supports 255 volume levels Drive supports multi-session discs and/or Photo-CD Drive uses a tray Drive's current reading speed is 5632 Kbyte/sec. Drive's maximum reading speed is 5632 Kbyte/sec. Each channel can be muted independently Each channel's volume can be controlled independently Tested media: Information for medium named "CD-R" Medium type code: 24h Drive recognizes this medium. Device can use the READ CAPACITY (10) command with this medium Device can use the READ (10) command with this medium Device can use the READ (12) command with this medium Device can use the READ CD command with LBA addressing with this medium Device can use the READ CD command with MM:SS:FF addressing with this medium Device can use the READ CD command with LBA addressing with this medium to read raw sector Device can use the READ CD command with MM:SS:FF addressing with this medium read raw sector Device can read the CD Absolute-Time-In-Pregroove from this medium Device can read the Table of Contents from this medium, without processing it Device can read the P to Q subchannels from this medium Device can read the Table of Contents from this medium